CVC Custom Builders uses 3D structural and coordination modelling to catch design conflicts early, so the details that define your work make it from drawing to finished home.

CVC models your design in 3D before construction starts, then runs clash detection across structure, mechanical, plumbing and electrical.
When conflicts appear, we resolve them with your team, not on site.
Resolve conflicts without losing the details that make the project distinct.
Architects and designers are included from the initial project start-up meeting onward, not brought in once problems appear.
Design changes and material substitutions go through a defined approval process, so nothing gets swapped out without your sign-off.
A cleaner build process means fewer compromises in the finished project.
CVC builds a full 3D model of the home from your architectural and structural drawings. Every wall, beam and structural component is modelled, so we frame the house digitally before a single piece of lumber is installed.
This is not a presentation rendering. It is a coordination tool. We layer in the mechanical, plumbing and electrical systems, run clash detection, and bring any conflicts to your team while the fix is still a design conversation.

As early as schematic design. CVC’s pre-construction process starts at that stage, and architects and designers attend the project start-up meeting. The 3D model begins once your architectural and structural drawings are available.
No. CVC flags the conflict, then works with your team and the trades to resolve it. The model supports your drawings. It does not replace them or the people who produced them.
More on the architect’s role in a Whistler custom build.
Anywhere the building systems collide with the structure. Common examples are a pipe running through a beam or ductwork interfering with framing. CVC models the structure first, then layers in mechanical, plumbing and electrical to run clash detection.
Your architectural and structural drawings. CVC starts there, adds the mechanical, plumbing and electrical systems, and brings any conflicts back to your team.
Designers and consultants attend CVC’s handover meeting. CVC reviews open RFIs, confirms each consultant’s capacity during construction, and sets an approval process for design changes and material substitutions.
Luxury Home Builders and General Contractors in Whistler and the Sea to Sky.
connect@cvcustombuilders.ca
604-815-3542